|
Panelglide
Display Systems
Seemless
Exhibit Systems - Set-up Instructions
|
|
| 1.
PANEL ASSEMBLY |
| 1-Do
NOT unfold panels. |
| 2-Stack
mid stripe sections (if included) onto bottom section
by inserting nylon pins into bottom section as shown. |
| 3-Stack
top section onto the mid=stripe (or bottom section if
there is no mid stripe) in the same manner. |
 |
| Panels
can be positioned by holding bottom of display and fanning
out the panels as indicated by the arrows. Never straighten
the system all the way out. You must have at least two
panels angled 45 degrees or more to the rest of the system
in order to maintain stability. |
|
| 2.
CURVE ASSEMBLY |
| To
assemble curves, swing aluminum brackets so that they
are at a right angle to the curve (as shown). Then
insert the nylon pin from the bracket into the opposite
bracket and secure with the velcro hook tape on the outside
of these brackets. |
 |
| |
| 3.
ATTACHING CURVES |
| Attached
curves to panels by sliding open-end of curved unit over
the edge of the bottom panel. It may be helpful
to slide it in a downward motion. Middle curved sections
may be attached in the same manner, taking care to insert
pin into the corresponding hold of the bottom unit and
tucking in flap behind bottom curved end unit. Repeat
this procedure for the top end curve section. Repeat on
other side of unit. |
 |
| |
| 4.
ATTACHING COMPONENTS |
| ALCOVE
COUNTER INSTRUCTIONS |
 |
After
setting up display system as shown, slip the four shelf
brackets between mid-stripe and lower panel as shown.
Joint the two pieces of the countertop by fastening spring
latches. Place countertop assembly on shelf brackets.
Attach doors beneath countertop at opposite ends. Place
modesty panel between sets of doors. |
SHELVING
Aluminum
shelving fits in between panels and comes either
slanted or straight. Also available is plastic
shelving which attaches to unit with velcro hook
tape.
|
Stabilizer
bars and lights fit over the top of the display.
Stabilizer bars are plastic channels that help
keep the display stabile at the hinges where a
flat backwall is desired.
|
|
HEADERS
(back side shown below)
Headers
that are 60" or longer are in two parts.
Connect the header pieces by latching them together
from the back. To place on display, slide pins
behind the wall of panels and position header
as far forward or back as you need. (The angle
of the panels will affect this.)
|
|
| |
| PENINSULA
COUNTER INSTRUCTIONS |
 |
- Attach
front quarter round panels to each other with the
wood spine provided.
- Add
back (flat section) to joined quarter rounds by sliding
this panel (40"h x 19"w) into u channels.
- Slip
two shelf brackets between mid stripe and lower panel
on display backwall.
- Position
half-round and place countertop to rest on brackets
and half round.
*
If included, attached the modesty panel beneath the
countertop. On the opposite side, attach the door and
7" fill panel.
|
| |
 |
Headers
(both halves) should be placed face to face inside the
foam tray provided.
Foam
Tray
Cardboard
Curve
(place fabric side down)
Curve
(place fabric side down)
Curve
(place fabric side down)
Curve
(place fabric side down)
Top
panels (accordian folded)
Case
|
|
|
