Laarhoven Design Ten Foot Displays

Reconfiguring Convertible

Convertible is the only pop-up display system that is truly modular and can be reconfigured in the field without the use of any tools.  Converting Convertible from a full-height backwall to a 2 quad display is very simple and can be done by one person in less than 10 minutes by following steps 1 through 5.

Determine Quads

To determine which hubs to unscrew, open frame slightly and determine how many quads the reconfiguration will have. Make sure that every quad has 4 hubs. After determination of which scissors need to be dismantled, follow the instructions 1 through 5.

Frame Lock Positions

Note that certain reconfiguration may require the movement of frame locks.  Simply unscrew locking hubs in same manner as standard hubs and relocate locks to desired position. NEVER UNSCREW ALL THE HUBS!

Place frame on floor with one set of hubs resting of floor and one set of hubs facing you. Open frame slightly so there are about six inches between each hub. Unscrew thumbscrew by hand and take off front part of hub. (to determine which thumbscrews to unscrew, see "determine quads" section of these instructions). Disengage desired parts of the frame and reattach hub front to hub back with thumbscrew. Turn over the frame and repeat. Store the unneeded parts in a safe place.