| |
 |
 |
| 1.
Turn image with picture side facing down. Peel back
small amount of protective strip on the top bar. |
2.
Place top bar against upper edge of image, remove
protective strip. Press firmly. |
 |
 |
| 3.
Turn image & bar over and burnish down bar to
insure good contact with adhesive. |
4.
Remove white protective strip from leader. Apply
image, picture side up. Follow blue line. |
 |
 |
| 5.
Apply image, picture side up. Follow the blue line. |
6.
Apply tape over joint on both sides. |
 |
 |
| 7.
Grip graphic & unit firmly with left hand. Remove
pin with right hand. (Pin stores in slot after completion). |
8.
Maintain a tight grip on graphic and gradually feed
into roller mechanism. |
 |
 |
| 9.
Continue to maintain a tight grip and feed into
roller mechanism. |
10.
You're finished! Your Magicpak is ready to show. |
| To
interchange graphics: |
 |
Extend
graphic all the way out of the unit and reinsert
locking pin. Remove old graphics from leader.
Use new top bar (you must obtain a new top
bar) and repeat installation steps. |
|